Avionics Databus Specialist YED - an Avionics Databus Specialist Company

Handheld 1553 Rx

Part Numbers: YED/DATAIR-1500/SR & /DR

(DATAIR-1500/SR & /DR models shown) 

The DATAIR-1500/SR Handheld MIL-STD-1553 Data Monitor is an easy to use diagnostic tool. The DATAIR-1500/SR provides a solution to most analysis and diagnostic requirements when viewing a MIL-STD-1553 bus, without having the inconvenience of carrying a PC notebook around. Its use is analogous to using a digital voltmeter for analogue applications. It allows connection of the MIL-STD-1553 Triax connector on the end of the handheld unit for instantaneous display of valuable MIL-STD-1553 information on bus traffic, polling rates, non-responding RT's, low word counts, etc. Data is also displayable in hexadecimal, binary and user definable engineering unit formats. An Engineering Units Definition Windows software package is supplied to allow definition of custom display formats. The DATAIR-1500/SR has a very simple to use menu structure via a 4 line by 16 character LCD and a three button interface.

 
 
RECEIVER:

Very simple to use intelligent MIL-STD-1553 Real
      Time Data Monitor.
Transformer coupled inputs with Triax connectors.
User definable Engineering Units Display.
Single redundant as standard (DATAIR-1500/SR).
Dual redundant with Bus A/B detect and ident
      (DATAIR-1500/DR)
No Status response indication.
Protocol error detection: High / Low Word count.
RS232 port for Download of Word definitions.
 
  OTHER:

Three button 4 line by 16-character LCD user
      interface.
Battery powered from 4xMN1500 dry cells.
Nickel painted EMC/RFI shielded enclosure.
Full EMC Compliance to European (CE) directive.
Weight: 750g (with batteries fitted)
External supply: 3 to 7.5 volts DC @ 270mA (at 3V)
External DC Connector: 3.5mm Jack.
      NOTE: The Tip of the Plug is +6V.
RS232 Connector: D9 filtered Plug
Environmental: 0 to 50 șC (operating)
 		  

The active RT, SA, Mode Codes and data words contained in a selected MIL-STD-1553 message are displayed in a scrollable list format, which can be scrolled by use of the << and >> cursor buttons. Once the flashing cursor is positioned over a selection of interest the centre button (SELECT) is pressed to make the selection.

Command and Status information for the selected RT/SA and T/R bit can be displayed which provides valuable information on the health of the bus. Information on the repetition rate of the selected message is provided to a resolution of 1mS.

The DATAIR-1500/DR provides information when analyzing dual redundant bus operation indicating activity on Bus A or B.

Click here to Download DATAIR-1500 User Manual in Word format (Zipped 618kB)
[PASSWORD PROTECTED - To request password click here.]
 

Click here to download the DATAIR-1500 brochure in Acrobat PDF format (299kB)

 

 

 

All units are designed to meet the European and US EMC regulations.

back to top

[Home] [Products] [About Us] [Support] [What's New] [Contact Us]

©YED Limited

Last Updated: 02 February, 2008 04:38 PM